Newsletter
|
1. product introduction
TYYC tuning fork level switch is a kind of universal material level switch. because it Inspired by the crystal the tuning fork produces vibration, the vibrational frequency getting changes when the tuning fork was immersion by the liquid or solid, and then the frequency changes were detected by electronic so that output a switching value to fulfill alarm and control. The structure and principle of this series can replace any kinds of mechanical liquid level switch. It is widely application in detention, metallurgy, light industry, building materials industry.
2. Characteristics
Well adapted: for measured material of different electrical parameters, there is no influence for different density. Neither no influence on the bad condition of scaling, mixing, turbulence, bubble, vibration, medium viscosity degrees, high temperature and high pressure.
No maintainance: because of the tuning fork level switch detection procession were fulfilled by electronic circuit, and no moving parts. So without maintanance after installtion.
Without set-up: due to the tuning fork level switch is not influence by measured medium’s electronic parameter and desity, so for any liquids it is not need set-up.
3. Typical application
3.1 Tap water, mineral water, paper pulp, glue, dye
3.2 Mud, alkali solution and acid solution.
3.3 Beer, beverage, can produce gas liquid.
3.4 Liquidity is good solid powder.
4. Model selection
| TYYC | Tuning fork level switch | ||||||||
| Code | Construction | ||||||||
| 1 | Integrated（temperature＜80℃） | ||||||||
| 2 | Integrated thermal （temperature＜150℃） | ||||||||
| 3 | Remote（temperature＜300℃） | ||||||||
| Code | Medium | ||||||||
| A | Solid | ||||||||
| B | Liquid | ||||||||
| C | Interface | ||||||||
| Code | Pressure （MPa） | ||||||||
| 1 | Atmospheric pressure type≤0.25MPa | ||||||||
| 2 | Compression type 0.25…1.0MPa | ||||||||
| 3 | High pressure type≤4.0MPa | ||||||||
| Code | Process connection | ||||||||
| A | flange（DN50/DN80/DN100） | ||||||||
| B | Thread install G1” | ||||||||
| C | Thread install G1” | ||||||||
| Code | Length of measuring rod（mm） | ||||||||
| L | According to customers’ need | ||||||||
| Code | Anti-static | ||||||||
| 1 | No | ||||||||
| 2 | Anti-static | ||||||||
| Code | Supply voltage | ||||||||
| A | 220VAC | ||||||||
| B | 24VDC | ||||||||
| Code | Explosive | ||||||||
| 1 | Without | ||||||||
| 2 | Explosion proof | ||||||||
5. Installation
Tuning fork level switch is usually adopted side way installation (in) on the side of the warehouse wall and capsule wall was carried out on the material level height of upper and lower position detection; When the warehouse inconvenience side hole we can adopt the top loading (at the top of the silo installation) way to install, location should choose to avoid the location of the shock when the feed materials; Neither material can be installed with the line to prevent the pump running.
TYSP Rf admittance level switch/ TYYC tuning fork level switch/TYZX rotor resistant switcher
